Minimal Desired Operating system Win98 Windows 2000 The solution for this problem is described in paragraph 5.1 of this guide.Ĭomputer requirements In order to run the Autolab software properly, your computer must comply with the following (minimum) requirements: This shows up as an Autolab Interface error or an iRMX error. With the newer PCs with a USB2 chipset it is possible that the measurement is halted after a while. How to do this is described in paragraph 4.1.ĥ. To avoid this problem, the Desktop can be changed to Windows classic layout. Toolbar buttons are shown half and text does not fit properly on the screen. Because of the different Windows XP layout the Autolab software windows are not displayed properly. You can ignore this message by pressing the Continue Anyway button.Ĥ. In Windows XP(Pro) you will get a message that the software you are installing for this hardware has not passed Windows Logo testing to verify its compatibility with Windows XP. After installation of the Autolab software this folder is available.ģ. All USB drivers can be loaded from the c:\Autolab\usb folder. Follow the instructions about switching on the Autolab-USB or USB Interface box exactly as described in chapter 4.Ģ.
Do NOT switch on the Autolab-USB or the USB Interface box before installation These points are also explained in the concerning chapters: 1. There are some points which are important during the installation of the USB. Chapter 5 explains what to do when the USB installation fails. It explains how to connect the Autolab Hardware to the PC (USB paragraph 2.1 and ISA IF020 paragraph 2.2), how to install the Autolab software (chapter 3) and how to install the correct drivers for the Autolab USB Interface (chapter 4). Read this first This manual is meant to guide you through the installation of the Autolab software and interface. 42 Standard jumper settings.42 Changing jumper settings. COMMUNICATION (CANNOT READ AUTOLAB) OR NOISE PROBLEMS WITH OLDER AUTOLAB INSTRUMENTS. 39 Re-load of the Autolab USB drivers.40ĥ.3. 37Ĭhecking USB drivers in Windows2000/XP.37 Checking USB drivers in Windows98/Me. INSTALLING THE USB DRIVER FOR WINDOWS ME. INSTALLING THE USB DRIVER FOR WINDOWS 98.26 4.4. INSTALLING THE USB DRIVER FOR WINDOWS 2000.22 4.3. INSTALLING THE USB DRIVER FOR WINDOWS XP.18 4.2. 7 Inserting the interface board.7 Configuring the interface board. ISA - IF020 INTERFACE.7 Computer requirements. 5 Connecting the Autolab-USB Interface box.5 Connecting the Autolab-USB or Autolab III (Internal). General Purpose Electrochemical System (GPES) for Windows - version 4.9Įco Chemie B.V.
0 kommentar(er)
